| Author |
Message |
    
Jon Meeker
Junior Member
Username: Jmeeker
Post Number: 49
Registered: 04-2003
Posted From: 71.219.78.21
| | Posted on Friday, August 28, 2009 - 12:07 am: | 
|
Just received an rtd probe from Auber and am confused about how to wire it to the quick disconnect. It uses 3 wires. 2 whites and 1 red. I've seen several different wiring diagrams on the internet but am not sure which to use. The quick disconnects have 3 pins and the rtd has 4 pins. Just not sure what wire goes to each numbered pin or if it even matters as long as they match on both ends. Any ideas? |
Tom Burk
Member
Username: Tomburk
Post Number: 198
Registered: 03-2003
Posted From: 66.231.37.17
| | Posted on Friday, August 28, 2009 - 03:52 am: |
|
Jon my rtd's came with the qd pre-wired. I have since shrink wrapped where the wire enters the qd. My thought is that it may matter, but I would call Auber about it. He has been very helpful when I have called.
If you can't get a good answer soon let me know and I'll cut back the shrink wrap and take a look.
I really like the electric brewing. |
Jon Meeker
Junior Member
Username: Jmeeker
Post Number: 50
Registered: 04-2003
Posted From: 71.219.78.21
| | Posted on Friday, August 28, 2009 - 04:15 pm: |
|
Thanks Tom. I'll call Auber. |
Brews and Views Archive 2009 
Closed: New threads not accepted on this page