Topics Topics Help/Instructions Help Edit Profile Profile Member List Register  
Search Last 1 | 3 | 7 Days Search Search Tree View Tree View  

Visit The Brewery's sponsor!
Brews & Views Bulletin Board Service * Brews and Views Archive 2003 * September 2, 2003 * Parts for non-weld keg conversion < Previous Next >

  Thread Last Poster Posts Pages Last Post
  Start New Thread        

Author Message
 

Leland Dunn (64.171.25.103)
Posted on Friday, August 15, 2003 - 07:45 pm:   Edit Post Delete Post View Post/Check IP    Ban Poster IP (Moderator/Admin only)

A while back somebody listed the parts with part numbers from Mcmaster-carr for a non-weld port valve for the bottom of a converted keg. I was hoping for somebody to post it again. I went to the Home Depot and I couldn't find the flat nut used to smash the silicon washer to the side of the keg to make a seal. Anyway, any help would be appreciated to putting together these pieces rather than buying a non weld kit (around $25). Thanks.
 

TexanBrewer (63.174.45.1)
Posted on Friday, August 15, 2003 - 07:55 pm:   Edit Post Delete Post View Post/Check IP    Ban Poster IP (Moderator/Admin only)

Here you go:

Note that you might also need two stainless steel washers.

http://www.texanbrew.com/article.php?story=20021108142950430

Scott
http://texanbrew.com

Add Your Message Here
Posting is currently disabled in this topic. Contact your discussion moderator for more information.