| Author |
Message |
    
Jeff Barber
New Member
Username: Jbarb1226
Post Number: 21
Registered: 03-2003
| | Posted on Friday, April 15, 2005 - 08:23 pm: | 
|
I am planning on putting a tap in my frig. Since I all ready have the hoses, ket, CO2 tank and regulator is all I need a nipple shank (5"), faucet and knob/handle?
Thanks
Jeff |
Jon Tupper
New Member
Username: Jon_up_north
Post Number: 5
Registered: 04-2005
| | Posted on Friday, April 15, 2005 - 08:26 pm: |
|
You'll also need at least a dozen beers and a drinking buddy. |
JimTanguay
Intermediate Member
Username: Pizzaman
Post Number: 429
Registered: 02-2003
| | Posted on Friday, April 15, 2005 - 10:49 pm: |
|
yep, and a way to drill a 1" hole. Are you going thru the door? |
Jeff Barber
New Member
Username: Jbarb1226
Post Number: 23
Registered: 03-2003
| | Posted on Sunday, April 17, 2005 - 06:46 am: |
|
Yes I am going through the door. |
Kent Fletcher
Advanced Member
Username: Fletch
Post Number: 708
Registered: 11-2002
| | Posted on Sunday, April 17, 2005 - 07:06 am: |
|
A 1" bimetal hole saw will do the trick. |
JimTanguay
Intermediate Member
Username: Pizzaman
Post Number: 432
Registered: 02-2003
| | Posted on Sunday, April 17, 2005 - 03:44 pm: |
|
I used a bimetal hole saw. it cut a little rough but it gets covered up. I'm working on a 15 cu freezer tommorrow when all my parts are supposed to get here
 |
Brews and Views Archive 2005 
Closed: New threads not accepted on this page